General Discussion > Other Government Agencies
SES trailer mounted flood pumps
Andrew:
Before I left Moore Engineering I did the design / Spec for the sturt pumping trailer.
From memory:
2000 LPM + pump capacity - it can pump solids - up to ?mm (I think 15odd mm) petrol powered. It was to be mounted in a manner as it could be lifted off the trailer and left on site, whilst the trailer was used for sand bagging.
All threads were to be SAMFB (london round) compliant - fully compatable with MFS and CFS. I have not had any contact since I left (5 months) - so I hope it worked out as originally specked.
- By the way I am loving it in QLD - I am off to AFAC next week, on the Quik Corp stand.
If anybody is in Melb, call by and say hi. We have our range of reels, a slip on unit and a new twin pump system - one high volume pump and a high pressure pump, low volume pump. It can be run both pumps at the same time - or individually.
corecutters:
Where are you based / working for now Andrew?
Good to hear all is going well !
CC
Andrew:
I am now on the sunshine coast in QLD, I am the manager - engineering and R&D Engineer for Quik Corp (AUST) Pty Ltd.
Basically sold up and moved the wife and two little rug rats up north.
I look after manufacture and assembly at Quik Corp - we make weed spraying equipment and fire fighting equipment (hose reels). www.quikcorp.biz - have a look.
I also do R&D work - developing new products - concentrating on fire. I have a new foam injection system - ready to be trialed some time soon. Also looking at CAFS units for slip on units - 300 - 120 litre size. We are also developing a post pump foam injection system.
I am enjoyng the change of pace and also the extra time at home since I have also given up SES (22 years is long enough)
dropm me a line geue@ozemaildotcomdotau - swap the "dot" for "."
Navigation
[0] Message Index
[*] Previous page
Go to full version